卷帘门经常应用于许多工厂车间，因为卷帘门具有开启方便、保温、冷却、昆虫、防风、防尘、隔音、防火、气味、照明等优点。卷帘门需要方便人或车辆进出，因此非常需要确保卷帘门的安全性能，卷帘门底部安全柔软，当卷帘门安全底部安装需要测试验收时，济南卷帘门厂告诉您需要注意这些步骤。

Rolling shutter doors are often used in many factories and workshops, because they have the advantages of convenient opening, heat preservation, cooling, insects, wind protection, dust prevention, sound insulation, fire prevention, smell, lighting, etc. The roller shutter door needs to be convenient for people or vehicles to enter and exit, so it is very necessary to ensure the safety performance of the roller shutter door. The bottom of the roller shutter door is safe and soft. When the installation of the roller shutter door's safety bottom needs to be tested and accepted, Jinan roller shutter door factory tells you to pay attention to these steps.

1、关闭卷帘门的急停键，打开卷帘门电控箱电源，按下底接收器面板学习键，检查信号接收器灯。

1. Close the emergency stop button of the rolling door, turn on the power supply of the rolling door electric cabinet, press the learning button on the bottom receiver panel, and check the signal receiver lamp.

2、按压几次快速门安全底部口袋内的压力软管，信号指示灯闪烁表示接收成功，反复按压底部压力软管，每次接收器灯亮测试信号连接完成。

2. Press the pressure hose in the safety bottom pocket of the fast door several times, and the signal indicator flashes to indicate successful reception. Press the bottom pressure hose repeatedly, and each time the receiver lights up, the signal connection is completed.

3、打开卷帘门的电控箱急停按钮，按下口袋底部的压力软管，卷帘门的门体接到信号后自动上升，门体正常运转。

3. Open the electric cabinet emergency stop button of the roller shutter door, press the pressure hose at the bottom of the pocket, the roller shutter door will automatically rise after receiving the signal, and the door will operate normally.

4、在测试卷帘门安全底部和使用卷帘门的过程中，如果发现电控箱无法接收安全底部信号，应注意检查安全底部发射器中的电池和底部压力软管。如果发现电池耗尽，应更换新电池。如果底部压力软管损坏、泄漏或泄漏，应密封。如有必要，应更换新的安全底部压力软管。

4. In the process of testing the safety bottom of the roller shutter door and using the roller shutter door, if it is found that the electric cabinet cannot receive the safety bottom signal, pay attention to check the battery and bottom pressure hose in the safety bottom transmitter. If the battery is found to be depleted, replace it with a new one. If the bottom pressure hose is damaged, leaking or leaking, it should be sealed. If necessary, replace the safety bottom pressure hose with a new one.

此外操作员是经常性的要检查好电动卷帘门的手动开关和手动升降装饰，以防止在紧急的情况下电动卷帘门会失灵，或者造成不必要的安全事故。

In addition, the operator should regularly check the manual switch and manual lifting decoration of the electric roller shutter door to prevent the electric roller shutter door from failing or causing unnecessary safety accidents in an emergency.

要保持轨道运行畅通，及时清理电动卷帘门的轨道，保持内部清洁，卷帘门电机和传动链条要经常加注润滑剂，检查控制箱内器件和开关控制盒，紧固接线端口，紧固螺丝等，清洁控制箱内、表面和按钮上的灰尘污物，防止按钮卡住而不能反弹。

Keep the track running smoothly, clean the track of the electric roller shutter door in time, and keep the interior clean. The motor and drive chain of the roller shutter door shall be regularly filled with lubricant, check the components in the control box and the switch control box, fasten the wiring ports, fasten the screws, etc., and clean the dust and dirt on the control box, surface and buttons to prevent the buttons from sticking and not rebounding.

卷帘门相关的测试验收注意步骤的相关内容就讲解到这里了，您对此有什么想了解的问题就来我们网站http://www.jnhsjlm.com进行咨询吧！

This is the end of the test and acceptance procedures related to rolling shutter doors. If you have any questions about this, please come to our website http://www.jnhsjlm.com Consult!